...
• Do NOT exceed Max Units of carton
• If Nesting package
...
logic is enabled at the SKU/Item level check nesting
...
Data to consider:
• linear or cubic measurements
...
• CUBE (Note – in some cases ONLY Cube will be provided)
• Gross Weight
• Nesting Factor –expressed as an incremental increase in 1 dimension, when # units is greater than 1. (X,Y,Z direction and a factor)
Carton/Tote information – CALLED CARTON GROUP
• Carton Type – Grouping of Carton Sizes into a single type. Types will be assigned to Item Lines
• Preference ranking (1 to N) – e.g. – preference is to use MEDIUM – but as required, due to single DIM or MAX, other carton may be used.
• Length, width and Height (LxWxH)
• MAX CUBE
• MAX WEIGHT
• MAX UNITS
• CUBE FILL TOLERANCE e.g. MUST Achieve 85% cubic fill.
Shown below are the steps on how to enable Auto Calculate (Default):
...
Step 3: Then we need to ENABLE AUTO CALCULATE in Package logic:
The system will use the nearest calculation of dimension from the package logic item list:
After Saving the packaging logic, the SKU number of the item will be available and can be used in getting a quote in Quote and Book.
Step 4: Get a quotation in Quote and Book Module.
The system will use the nearest calculation of dimension from the package logic item list:
...